• Flex cable (FOS) drawings, with pad pinout configuration (Up and Down)
• HGA Drawings (Up and Down)
• Sample HGAs (Up and Down)

The following is a list of requirements to integrate an HSA with the QST-2002 system:

• Preamp Chip specifications
• Sample HSAs, including shipping comb
• HSA flex circuit mechanical layout diagram
• HSA flex circuit schematic

• HSA drawings (top and side views) of assembled HSA (with pivot bearing, if installed during test)
• HSA drawings of pivot hard stop reference surface
• Detailed dimensions of HSA mounting surface or pivot bearing (including bore size and tolerances)

• 3-D model of assembled HSA importable to ACAD 14 (recommended, but not required)
• X/Y distance from Pivot Point to Head Gap
• Sample(s) of flex connector used on drive PCB (or detailed specifications and drawings)
• Direction of rotation of Spindle

• Drawings of shipping comb

The following is a list of requirements to integrate an HDA with the QST-2002 system (note that many of these items are duplicated from the HSA integration requirements):

• Preamp Chip specifications
• Sample HDAs
• HSA flex circuit mechanical layout diagram
• HSA flex circuit schematic

• HDA drawings, showing flex circuit connector location and installation height, and HSA park position

• Sample(s) of flex connector used on drive PCB (or detailed specifications and drawings)
• Direction of rotation of Spindle