MagnetActuator Release Notes

Version 1.1.8
- Fixed: Previous version still did not save com port

Version 1.1.7
- Fixed: In HGA mode the software homed the magnet, but did not move to any position. Now user can set up Z position of the Magnet for HGA and use that for both heads. 
- Fixed: Runtime error when changing the COM port in the HSA menu

Version 1.1.6
- Fixed: Sometimes the stage would stop with an error: "Could not move to position <>. Reason Unkown". 

Version 1.1.5
- Fixed: Software did not check if tester configuration was HSA/HDA

Version 1.1.4
- Fixed: Software did not ask to save program, if user was in the middle of editing it and selected another program.

Version 1.0.0
- Added Position sets and moving to heads on currenthead event

Version 1.0.0
- Initial Release
- Diagnostics functions are ready.